全國熱線服務:
新聞資訊 Top label
- The Essential Guide to Hollow Shafts in Modern Mechanical Systems
- The Essential Guide to Cylinder Barrel Technology: Applications, Specifications, and Industry Standards
- The Complete Guide to Welded Ductwork: Industrial Applications and Technical Specifications
- The Essential Guide to Pressure Sensors: Technology, Specifications, and Industrial Applications
- Optimizing Ball Mill Performance: A Complete Guide for Industrial Grinding Operations
- Total Phosphorus Water Quality Analyzer: Technology, Applications, and Selection Guide
Causes and troubleshooting methods for crawling when hydraulic cylinders are working
Hydraulic cylinderThe causes and troubleshooting methods of crawling during work are as follows:
1) There is air intrusion into the cylinder. An exhaust device should be added, or the hydraulic cylinder should be moved rapidly at its maximum stroke to force the air out.
2) The sealing ring at the end cover of the hydraulic cylinder is pressed too tightly or too loosely. The sealing ring should be adjusted to have appropriate tightness to ensure that the piston rod can be pulled back and forth smoothly by hand without leakage.
3) The coaxiality of the piston and the piston rod is not good. Should be corrected and adjusted.
4) The hydraulic cylinder is not parallel to the guide rail after installation. It should be adjusted or reinstalled.
5) The piston rod is bent. The piston rod should be straightened.
6) The piston rod has poor rigidity. Increase the piston rod diameter.
7) The gap between the moving parts of the hydraulic cylinder is too large. The fit gap should be reduced.
8) The installation position of the hydraulic cylinder is offset. The parallelism between the hydraulic cylinder and the guide rail should be checked and corrected.
9) The inner diameter of the hydraulic cylinder is linearly poor (drum-shaped, tapered, etc.). It should be repaired and the piston reinstalled.
10) Corrosion and roughening in the cylinder. Rust and burrs should be removed, and if necessary, boring should be performed.
11) The nuts at both ends of the piston rod of the double-rod piston cylinder are tightened too much, causing poor concentricity. The nut should be loosened slightly so that the piston is in its natural state.